U gebruikt een browser die we niet langer ondersteunen. Kies een van de volgende ondersteunde browsers om onze website te blijven bezoeken.
There are many industries and processes where compressed air and nitrogen are used at higher pressures of up to 40 bar. PET blowing, laser cutting, pressure tests and abrasive cutting are among some of the widespread processes in which air or nitrogen boosters can be an integral part of the installation. The BSTAIR booster can be connected to the plant’s low-pressure network. The standard booster range has a discharge pressure of up to 40 bar, with a flow range of 0.4 m3/min to 3.6 m3/min.
- Low oil carryover with the use of special oil retention system
- High-quality component materials
- Direct drive transmission
- A highly efficient IE3 IP55 motor
- Strong anti-vibration dampers
- Well balanced, V-type, single-stage pump
- Advanced materials and treatment of main components
- Robust, reliable design and easy access for service
- Low vibration level
- Highly efficient IE3 motor as standard
- Fully enclosed air-cooled, IP55, F-class motor for heavy-duty operation
- Low electrical peaks
- Gradual stop of the motor
- 24V transformer is installed inside the cubicle
Air or nitrogen is compressed in a single-stage pump using the standard operating cycle of a piston compressor. Compression starts at a low pressure moving through the joint work of the inlet and outlet solenoid valves. The compressed air or nitrogen then enters the booster where it is further compressed up to 40 bar, in a single stage. The inlet pressure switch stops the booster when the inlet pressure exceeds the maximum allowed value or drops below the minimum allowed value. Cooling is provided by the axial fan installed on the shaft of the booster.
The booster is lubricated by the oil in the crankcase. The crankcase is vented via the oil separator and the oil breather, which allows operation with minimum oil carryover.
Postbus 316
5340 AH Oss
Galliërsweg 27, 5349 AT, Oss
Kvk Den Bosch 16034067
BTW nr. NL001246173B01
IBAN: NL26DEUT0265141176
BIC DEUTNL2A
Bel voor storing 0412-664111
Bel voor onderhoud 0412-664117
Voor algemene vragen en info bel 0412-664190
E-mail: contact@alupgrassair.nl